CLI Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information You must reload Dell Networking OS after executing this command. Use the
command upgrade system stack-unit to copy Dell Networking OS from the
management unit to one or more stack members.
Example
Dell#upgrade system ?
flash: Copy from flash file system (flash://filepath)
ftp: Copy from remote file system, IPv4 or IPv6,
(ftp:/
/userid:password@hostip/filepath)
scp: Copy from remote file system, IPv4 or IPv6,
(scp:/
/userid:password@hostip/filepath)
stack-unit Sync image to the stack-unit
tftp: Copy from remote file system, IPv4 or IPv6,
(tftp:/
/hostip/filepath)
usbflash: Copy from usbflash file system (usbflash://
filepath)
Dell#
verify
Validate the software image on the flash drive after the image has been transferred to the system, but
before the image has been installed.
Syntax verify { md5 | sha256 }[ flash:// ] img-file [hash-value]
Parameters
md5 Enter the md5 keyword to use the MD5 message-digest
algorithm.
sha256
Enter the sha256 keyword to use the SHA256 Secure Hash
Algorithm
flash:// (Optional). Enter the flash:// keyword. The default is to
use the flash drive. You can just enter the image file name.
img-file Enter the name the Dell Networking software image file to
validate.
hash-value (Optional). Enter the relevant hash published on i-Support.
Defaults flash drive
Command Modes EXEC mode
File Management
85