CLI Guide

IPv6 MBGP Commands
Multiprotocol BGP (MBGP) is an enhanced BGP that enables multicast routing policy throughout the
Internet and connecting multicast topologies between BGP and autonomous systems (AS). The Dell
Networking MBGP is implemented as per IETF RFC 1858.
address family
This command changes the context to subsequent address family identifier (SAFI).
Syntax
address family ipv6 unicast
To remove SAFI context, use the no address family ipv6 unicast
command.
Parameters
ipv6 Enter the keyword ipv6 to specify the address family as
IPv6.
unicast Enter the keyword unicast to specify multicast as SAFI.
Defaults IPv6 Unicast
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
After this command is executed, all subsequent commands apply to this address
family. You can exit from this AFI/SAFI to the IPv6 Unicast (the default) family by
entering the exit command and returning to the Router BGP context.
aggregate-address
Summarize a range of prefixes to minimize the number of entries in the routing table.
Syntax
aggregate-address ipv6-address prefix-length [advertise-map
map-name] [as-set] [attribute-map map-name] [summary-only]
[suppress-map map-name]
Parameters
ipv6-address
prefix-length
Enter the IPv6 address in the x:x:x:x::x format then the prefix
length in the / x format. The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
IPv6 Border Gateway Protocol (IPv6 BGP)
847