CLI Guide

CISCO_ROUTE_REFRESH(128)
For address family: IPv6 Unicast
BGP table version 12, neighbor version 12
2 accepted prefixes consume 32 bytes
Prefix advertised 0, rejected 0, withdrawn 0
Connections established 3; dropped 2
Last reset 00:00:41, due to Closed by neighbor
Notification History
'OPEN error/Bad AS' Sent : 0 Recv: 1
Local host: 5ffe:11::4, Local port: 179
show ip bgp ipv6 unicast peer-group
Allows you to view information on the BGP peers in a peer group.
Syntax
show ip bgp ipv6 unicast peer-group [peer-group-name [summary]]
Parameters
peer-group-name (OPTIONAL) Enter the name of a peer group to view
information about that peer group only.
detail (OPTIONAL) Enter the keyword detail to view peer-
group-specific information for the IPv6 address family.
summary (OPTIONAL) Enter the keyword summary to view status
information of the peers in that peer group. The output is
the same as that found in the show ip bgp ipv6
unicast summary
command.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#show ip bgp peer-group
Peer-group RR-CLIENT, remote AS 18508
BGP version 4
Minimum time between advertisement runs is 5 seconds
For address family: IPv4 Unicast
BGP neighbor is RR-CLIENT, peer-group internal,
Number of peers in this group 1
Peer-group members (* - outbound optimized):
9000::4:
Peer-group RR-CLIENT-PASSIV, remote AS 18508
IPv6 Border Gateway Protocol (IPv6 BGP)
841