CLI Guide

Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The software resolves the network address configured by the network command
with the routes in the main routing table to ensure that the networks are reachable
using non-BGP routes and non-default routes.
Related
Commands
redistribute — redistributes routes into BGP.
network backdoor
Specify this IGP route as the preferred route.
Syntax
network ipv6-address prefix-length backdoor
To remove a network, use the no network ipv6-address prefix-length
backdoor command.
Parameters
ipv6-address
prefix-length
Enter the IPv6 address in the x:x:x:x::x format then the prefix
length in the /x format. The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information Though the system does not generate a route due to backdoor config, there is an
option for injecting/sourcing a local route in presence of network backdoor config
on a learned route.
redistribute
Redistribute routes into BGP.
Syntax
redistribute {connected | static} [route-map map-name]
IPv6 Border Gateway Protocol (IPv6 BGP)
827