CLI Guide

Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
Entering a no debug ip bgp command removes all configured debug
commands for BGP.
debug ip bgp updates
Allows you to view information about BGP updates.
Syntax
debug ip bgp [ipv6-address | peer-group peer-group-name | ipv6
unicast [ipv6-address]] updates [in | out | prefix-list prefix-
list-name]
To disable debugging, use the no debug ip bgp [ip-address | peer-group
peer-group-name | ipv6 unicast [ipv6-address]] updates [in |
out] command.
Parameters
ipv6-address (OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format
then the prefix length in the /x format. The range is from /0
to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group peer-
group-name
(OPTIONAL) Enter the keywords peer-group then the
name of the peer group.
ipv6 unicast [ipv6-
address]
(OPTIONAL) Enter the keywords ipv6 unicast, and,
optionally, an ipv6 address.
in (OPTIONAL) Enter the keyword in to view only BGP
updates received from neighbors.
out (OPTIONAL) Enter the keyword out to view only BGP
updates sent to neighbors.
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
804
IPv6 Border Gateway Protocol (IPv6 BGP)