CLI Guide

NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group peer-
group-name
(OPTIONAL) Enter the keywords peer-group then the
name of the peer group.
in (OPTIONAL) Enter the keyword in to view only inbound
keepalive messages.
out (OPTIONAL) Enter the keyword out to view only outbound
keepalive messages.
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
Entering a no debug ip bgp command removes all configured debug
commands for BGP.
debug ip bgp notifications
Allows you to view information about BGP notifications received from neighbors.
Syntax
debug ip bgp [ipv6-address | peer-group peer-group-name]
notifications [in | out]
To disable debugging, use the no debug ip bgp [ip-address | peer-group
peer-group-name] notifications [in | out] command.
Parameters
ipv6-address (OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format
then the prefix length in the /x format. The range is from /0
to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group peer-
group-name
(OPTIONAL) Enter the keywords peer-group then the
name of the peer group.
in (OPTIONAL) Enter the keyword in to view BGP notifications
received from neighbors.
out (OPTIONAL) Enter the keyword out to view BGP
notifications sent to neighbors.
Command Modes EXEC Privilege
IPv6 Border Gateway Protocol (IPv6 BGP)
803