CLI Guide

show ipv6 route
Displays the IPv6 routes.
Syntax
show ipv6 route [ipv6-address prefix-length] [hostname] [all]
[bgp as number] [connected] [isis tag] [list prefix-list name]
[ospf process-id] [rip] [static] [summary]
Parameters
ipv6-address
prefix-length
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format
then the prefix length in the /x format. The range is from /0
to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
hostname (OPTIONAL) View information for this IPv6 routes with Host
Name.
all (OPTIONAL) View information for all IPv6 routes.
bgp (OPTIONAL) View information for all IPv6 BGP routes.
connected (OPTIONAL) View only the directly connected IPv6 routes.
isis (OPTIONAL) View information for all IPv6 IS-IS routes.
list (OPTIONAL) View the IPv6 prefix list.
ospf (OPTIONAL) View information for all IPv6 OSPF routes.
rip (OPTIONAL) View information for all IPv6 RIP routes.
static (OPTIONAL) View only routes configured by the ipv6
route command.
summary (OPTIONAL) View a brief list of the configured IPv6 routes.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following describes the show ipv6 route command shown in the following
examples.
Field Description
(undefined) Identifies the type of route:
774
IPv6 Basics