CLI Guide

Usage Information If the flowlabel value is already set for BGP or SSH, the system defaults to the
already configured value. All packets on the same connection are considered part
of the same flow by the system. For new connections, set the new flowlabel to
zero.
ipv6 host
Assign a name and IPv6 address the host-to-IPv6 address mapping table uses.
Syntax
ipv6 host name ipv6-address
To remove an IP host, use the no ipv6 host name {ipv6–address}.
Parameters
name Enter a text string to associate with one IP address.
ipv6-address Enter the IPv6 address (X:X:X:X::X) to be mapped to the
name.
Defaults Not configured.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
ipv6 name-server
Enter up to six IPv6 addresses of name servers. The order you enter the addresses determines the order
of their use.
Syntax
ipv6 name-server ipv6-address [ipv6-address2... ipv6-address6]
To remove a name server, use the no ipv6 name—server ipv6–address
command.
Parameters
ipv6-address Enter the IPv6 address (X:X:X:X::X) of the name server to be
used.
NOTE: The :: notation specifics successive hexadecimal
fields of zeros.
IPv6 Basics
761