CLI Guide

Usage Information
• Both sides of the link must specify the same transform set.
• You can create up to 64 transform sets.
Example
Dell(conf)#int ten 0/4
Dell(conf-if-te-0/4)#ipv6 address 200:1::/64 eui64
Dell(conf)#int ten 0/6
Dell(conf-if-te-0/6)#ipv6 address 801:10::/64 eui64
crypto ipsec policy
Create a crypto policy used by ipsec.
Syntax
crypto ipsec policy name seq-num ipsec-manual
To delete a crypto policy entry, use the no crypto ipsec policy name seq-
num ipsec-manual command.
Parameters
name Enter the name for the crypto policy set.
seq-num Enter the sequence number assigned to the crypto policy
entry.
Defaults none
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information This command creates a crypto policy entry and enters the crypto policy
configuration mode for configuring the flow parameters.
Example
Dell(conf)#crypto ipsec policy West 10 ipsec-manual
Dell(conf-crypto-policy)#
management crypto-policy
Apply the crypto policy to management traffic.
Syntax
management crypto-policy name
740
Internet Protocol Security (IPSec)