CLI Guide

nvram Enter the keyword nvram to reset the NvRAM only.

Command Modes EXEC Privilege

Supported Modes All Modes

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

9.4(0.0) Supported on the FN I/O aggregator.

8.3.17.0 Supported on the M I/O Aggregator.

Usage Information

Restoring factory defaults deletes the existing startup configuration and all persistent settings

(stacking, fanout, and so forth).

When restoring all units in a stack, all the units in the stack are placed into stand-alone mode.

When restoring a single unit in a stack, that unit placed in stand-alone mode. No other units

in the stack are affected.

When restoring units in stand-alone mode, the units remin in stand-alone mode after the

restoration. After the restore is complete, the units power cycle immediately.

CAUTION: There is no undo for this command.

Example

Dell#restore factory-defaults stack-unit 0 clear-all

***********************************************************************

* Warning - Restoring factory defaults will delete the

existing *

* startup-config and resets all persistent settings

(stacking, *

* fanout, etc.) and boot environment variables (boot config,

console *

* baud rate, management interface settings,

etc.) *

* After restoration the unit(s) will be powercycled

immediately. *

* Proceed with

caution ! *

***********************************************************************

Proceed with factory settings? Confirm [yes/no]:yes

-- Restore status --

Unit Nvram Config Bootvar

-----------------------------------

0 Success Success Success

Dell#

Example (NvRAM,

all)

Dell#restore factory-defaults stack-unit all nvram

**************************************************************

* Warning - Restoring factory defaults will delete the existing *

File Management