CLI Guide

Total 1388 2
Total 1388 active route(s) using 222440 bytes
Total 2 non-active route(s) using 128 bytes
Dell>
Related
Commands
show ip route — displays information about the routes found in the switch.
show ip traffic
View IP, ICMP, UDP, TCP and ARP traffic statistics.
Syntax
show ip traffic
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following describes the show ip traffic summary shown in the following
example.
Keyword Definition
unknown
protocol...
No receiver for these packets. Counts packets whose
protocol type field is not recognized by the system.
not a gateway... Packets can not be routed; the host/network is unreachable.
security failures... Counts the number of received unicast/multicast packets
that could not be forwarded due to:
• route not found for unicast/multicast; ingress interfaces
do not belong to the destination multicast group
• destination IP address belongs to reserved prefixes; the
host/network is unreachable
bad options... Unrecognized IP option on a received packet.
Frags: IP fragments received.
... reassembled Number of IP fragments that were reassembled.
... timeouts Number of times a timer expired on a reassembled queue.
... too big Number of invalid IP fragments received.
... couldn’t
fragment
Number of packets that could not be fragmented and
forwarded.
IPv4 Routing
733