CLI Guide

show ip management-route
View the IP addresses assigned to the Management interface.
Syntax
show ip management-route [all | connected | summary | static]
Parameters
all (OPTIONAL) Enter the keyword all to view all IP addresses
assigned to all Management interfaces on the switch.
connected (OPTIONAL) Enter the keyword connected to view only
routes directly connected to the Management interface.
summary (OPTIONAL) Enter the keyword summary to view a table
listing the number of active and non-active routes and their
sources.
static (OPTIONAL) Enter the keyword static to view non-active
routes also.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Example
Dell#show ip management-route
Destination Gateway State
----------- ------- -----
10.1.2.0/24 ManagementEthernet 0/0 Connected
172.16.1.0/24 10.1.2.4 Active
Dell#
show ip multicast-cam stack-unit
Displays content-addressable memory (CAM) entries.
Syntax
show ip multicast-cam stack-unit 0-5 port-set pipe-number [ip-
address mask [longer-prefixes] | detail | member-info |
summary]
Parameters
0-5 Enter the stack-unit ID, from 0 to 5.
726
IPv4 Routing