CLI Guide

show ip interface
View IP-related information on all interfaces.
Syntax
show ip interface [interface | brief] [configuration]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For the Management interface, enter the keyword
ManagementEthernet followed by zero (0).
• For a Port Channel interface, enter the keywords port-
channel
followed by a number. The range is from 1 to
128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a VLAN, enter the keyword vlan followed by a
number from 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a brief
summary of the interfaces and whether an IP address is
assigned.
configuration (OPTIONAL) Enter the keyword configuration to display
the physical interfaces with non-default configurations only.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information The following describes the show ip interface command shown in the
following example.
Lines Description
TenGigabitEthern
et 0/0...
Displays the interface’s type, slot/port and physical and line
protocol
Internet address... States whether an IP address is assigned to the interface. If
one is, that address is displayed.
IP MTU is... Displays IP MTU value.
Inbound access... Displays the name of the any configured incoming access
list. If none is configured, the phrase “not set” is displayed.
724
IPv4 Routing