CLI Guide

• When the interface comes up, Dell Networking OS re-installs the route.
• When recursive resolution is “broken,” Dell Networking OS withdraws the route.
• When recursive resolution is satisfied, Dell Networking OS re-installs the route.
Related
Commands
show ip route — views the switch routing table.
ip source-route
Enable the system to forward IP packets with source route information in the header.
Syntax
ip source-route
To drop packets with source route information, use the no ip route-source
command.
Defaults Enabled.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
ip tcp initial-time
Define the wait duration in seconds for the TCP connection to be established.
Syntax
ip tcp initial-time <8-75>
To restore the default behavior, which causes the wait period to be set as eight
seconds, use the no ip tcp initial-time command.
Parameters
<8-75> Wait duration in seconds for the TCP connection to be
established.
Command Modes
CONFIGURATION
Supported Modes Full–Switch
714
IPv4 Routing