CLI Guide

• enable DNS with the ip domain-lookup command
To view current bindings, use the show hosts command. To view a DNS-related
configuration, use the
show running-config resolve command.
Related
Commands
ip domain-name — specifies a DNS server.
ip domain-lookup
To address resolution (that is, DNS), enable dynamic host-name.
Syntax
ip domain-lookup
To disable DNS lookup, use the no ip domain-lookup command.
Defaults Disabled.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
To fully enable DNS, also specify one or more domain name servers with the ip
name-server command.
The Dell Networking OS does not support sending DNS queries over a VLAN. DNS
queries are sent out all other interfaces, including the Management port.
To view current bindings, use the show hosts command.
Related
Commands
ip name-server — specifies a DNS server.
show hosts — Views the current bindings.
ip domain-name
Configure one domain name for the switch.
Syntax
ip domain-name name
IPv4 Routing
705