CLI Guide

count value (OPTIONAL) Enter the keyword count then the count value.
The range is from 1 to 65534. The default is Infinity.
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For the Management interface, enter the keyword
ManagementEthernet then the slot/port information.
The slot range is from 0 to 1 and the port range is 0.
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN, enter the keyword vlan then a number
from 1 to 4094.
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following describes the debug ip packet command in the following
example.
Field Description
s= Lists the source address of the packet and the name of the
interface (in parentheses) that received the packet.
d= Lists the destination address of the packet and the name of
the interface (in parentheses) through which the packet is
being sent out on the network.
len Displays the packet’s length.
sending, rcvd,
fragment, sending
broad/multicast
proto, unroutable
The last part of each line lists the status of the packet.
TCP src= Displays the source and destination ports, the sequence
number, the acknowledgement number, and the window
size of the packets in that TCP packets.
UDP src= Displays the source and destination ports for the UDP
packets.
ICMP type= Displays the ICMP type and code.
IP Fragment States that it is a fragment and displays the unique number
identifying the fragment (Ident) and the offset (in 8-byte
IPv4 Routing
701