CLI Guide

24
IPv4 Routing
The aggregator supports both IPv4 and IPv6 routing and these are used only for the management
purpose.
This chapter describes the IPv4 related commands. They are:
• clear tcp statistics
• debug ip dhcp
• debug ip icmp
• show ip management-route
• show ip multicast-cam stack-unit
• show ip interface
• show ip route
• show tcp statistics
arp
To associate an IP address with a multicast MAC address in the switch when you configure multicast
mode of the network load balancing (NLB), use the address resolution protocol (ARP).
Syntax
arp ip-address multicast-mac-address interface
To remove an ARP address, use the no arp ip-address command.
Parameters
ip-address Enter an IP address in dotted decimal format.
multicast-mac-
address
Enter a 48–bit hexadecimal address in MAC address in
nn:nn:nn:nn:nn:nn format for the static MAC address to be
used to switch multicast traffic..
interface (OPTIONAL) Enter any of the following keywords and slot/
port or number information:
• For the Management interface, enter the keyword
ManagementEthernet then the slot/port information.
The slot range is from 0 to 1 and the port range is 0.
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• The interface specified here must be one of the
interfaces configured using the {output-range |
692
IPv4 Routing