CLI Guide

Command Modes INTERFACE
Supported Modes All Modes
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information
This command is found on the 1000/10000 Base-T Ethernet interfaces.
When you enable auto, the system performs and automatic discovery to
determine the optics installed and configure the appropriate speed.
When you configure a speed for the 1000/10000 interface, confirm the
negotiation auto command setting. Both sides of the link must should have
auto-negotiation either enabled or disabled. For speed settings of 1000 or auto,
the software sets the link to auto-negotiation and you cannot change that setting.
Related
Commands
stack-unit port-group port mode ethernet
Converts the interfaces 9 and 10 from Fibre Channel mode to Ethernet.
Syntax
stack-unit unit number port-group 0 portmode ethernet
To convert the interfaces 9 and 10 from Ethernet to Fibre Channel mode, use the
no stack-unit unit number port-group 0 portmode ethernet.
Parameters
stack-unit Enter the keyword stack-unit followed by a stack
member number to select the stack unit. The range is 0 to 5.
port-group Enter the keyword port-group followed by 0.
portmode
ethernet
Enter the keyword portmode ethernet to convert the
interfaces from Fibre Channel mode to Ethernet.
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.6(0.0) Supported on the FN2210S Aggregator.
688
Interfaces