CLI Guide

show ip udp-helper
Display the configured UDP helpers on all interfaces.
Syntax
show ip udp-helper
Defaults none
Command Modes EXEC
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#show ip udp-helper
--------------------------------------------------
Port UDP port list
--------------------------------------------------
Te 1/1 656, 658
Te 1/2 All
Related
Commands
debug ip udp-helper — enables debug and displays the debug information on a
console.
ip udp-broadcast-address — configures a UDP IP address for broadcast.
ip udp-helper udp-port — enables the UDP broadcast feature on an interface either
for all UDP ports or a specified list of UDP ports.
Port Interface Commands
The following commands are for physical, loopback, and null interfaces:
• clear counters
• clear mac-address-table dynamic
• interface range
• interface vlan
• keepalive
• name
• show config (INTERFACE mode)
• show config (from INTERFACE RANGE mode)
• show config (from INTERFACE VLAN mode)
• show interfaces configured
• show interfaces description
678
Interfaces