CLI Guide

Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 5d5h24m
Queueing strategy: fifo
Input Statistics:
0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte
pkts
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte
pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 5d5h23m
!-------------output truncated ----------------!
Related
Commands
show diag — Displays data plane and management plane input/output statistics.
show interfaces status
Displays a summary of interface information or specify a stack unit and interface to display status
information for that specific interface only.
Syntax
show interfaces [interface | stack-unit unit-number] status
Parameters
interface (OPTIONAL) Enter one of the following keywords and slot/
port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
unit-number Enter the stack unit’s ID number. The range is from 0 to 5.
NOTE: This command also enables you to view information corresponding to
a range of ports.
• You can specify multiple ports as slot/port-range. For example, if you
want to display information corresponding to all ports between 1 and 4,
specify the port range as
show interfaces interface-type 1/1 -
4.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Interfaces
653