CLI Guide

• auto-negotiation enabled* speed 1000 or auto

• auto-negotiation enabled speed 100

• auto-negotiation disabled speed 100

• auto-negotiation enabled* speed 1000 or auto

Port 1

• auto-negotiation enabled* speed 1000 or auto

• auto-negotiation enabled speed 100

• auto-negotiation disabled speed 100

• auto-negotiation enabled speed 100

• auto-negotiation disabled speed 100

Link Status Between Port 1 and Port 2

• Up at 1000 Mb/s

• Up at 100 Mb/s

• Down

* You cannot disable auto-negotiation when the speed is set to 1000 or auto.

Commands

speed (for 1000/10000 interfaces) — sets the link speed to 10, 100, 1000 or auto-

negotiate the speed.

portmode hybrid

To accept both tagged and untagged frames, set a physical port or port-channel. A port configured this

way is identified as a hybrid port in report displays.

Syntax

portmode hybrid

To return a port to accept either tagged or untagged frames (non-hybrid), use the

no portmode hybrid command.

Defaults non-hybrid

Command Modes INTERFACE (conf-if-interface-slot/port)

Supported Modes Full–Switch

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

9.2(0.0) Introduced on the M I/O Aggregator.

8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.

Interfaces

641