CLI Guide

Interfaces

This chapter defines the interface commands on the Aggregator switch.

Basic Interface Commands

The following commands are for Physical, Loopback, and Null interfaces.

clear counters

Clear the counters used in the show interfaces commands for VLANs, and physical interfaces, or

selected ones.

Syntax

clear counters interface

Defaults Without a specific interface specified, the command clears all interface counters.

Parameters

interface (OPTIONAL) Enter any of the following keywords and slot/

port or number to clear counters from a specified interface:

• For the management interface on the stack-unit, enter

the keyword managementethernet followed by slot/

port information. The slot and port range is 0.

• For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet followed by the slot/port

information.

• For a Port Channel interface, enter the keyword port-

channel followed by a number. Range: 1-128

NOTE: This command also enables you to clear the port

configurations corresponding to a range of ports.

• You can specify multiple ports as slot/port-

range. For example, if you want to clear the port

configurations corresponding to all ports between 1

and 4, specify the port range as

show interfaces

interface-type 1/1 - 4.

Command Modes EXEC Privilege

Supported Modes All Modes

Interfaces

617