CLI Guide

Defaults Not configured.

Command Modes INTERFACE VLAN — (conf-if-vl-n)

Supported Modes Programmable-Mux (PMUX)

Full–Switch

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

9.4(0.0) Supported on the FN I/O Aggregator.

9.2(0.0) Introduced on the M I/O Aggregator.

Usage Information This command enables the IGMP switch to send General Queries periodically. This

behavior is useful when there is no multicast router present in the VLAN because

the multicast traffic is not routed. Assign an IP address to the VLAN interface for the

switch to act as a querier for this VLAN.

ip igmp version

Manually set the version of the router to IGMPv2 or IGMPv3.

Syntax

ip igmp version {2 | 3}

Parameters

2 Enter the number 2 to set the IGMP version number to

IGMPv2.

3 Enter the number 3 to set the IGMP version number to

IGMPv3.

Defaults 2 (that is, IGMPv2)

Command Modes INTERFACE