CLI Guide

• For a VLAN, enter the keyword vlan followed by a
number from 1 to 4094.
Command Modes EXEC Privilege
Supported Modes All Modes
Default None.
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage information
The renew dhcp command is used to renew the lease of IP address obtained
through dhcp.
To display the currently configure dynamic IP address and lease time, enter the
show ip dhcp lease command.
show ip dhcp client statistics
Displays DHCP client statistics, including the number of DHCP messages sent and received on an
interface.
Syntax
show ip dhcp client statistics interface type slot/port
Parameters
interface type
slot/port
Display DHCP client statistics on the specified interface.
• For the management interface on the stack-unit, enter
the keyword managementethernet followed by slot/
port information. The slot and port range is 0.
• For a VLAN, enter the keyword vlan followed by a
number from 1 to 4094.
Command Modes EXEC Privilege
Supported Modes All Modes
Default None.
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Dynamic Host Configuration Protocol
529