CLI Guide

Version Description
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information
In the I/O Aggregator, the DHCP client is enabled only on the default VLAN and
management interface 0/0. Use the ip address command to assign a static IP
address that overwrites the dynamically assigned IP address.
Other Commands Supported by the DHCP Client
The following commands are supported by the DHCP client.
clear ip dhcp client statistics
Displays DHCP client statistics, including the number of DHCP messages sent and received on an
interface.
Syntax
clear ip dhcp client statistics interface type slot/port
Parameters
interface type
slot/port
Clear DHCP client statistics on the specified interface.
• For the management interface on the stack-unit, enter
the keyword managementethernet followed by slot/
port information. The slot and port range is 0.
• For a VLAN, enter the keyword vlan followed by a
number from 1 to 4094.
Command Modes EXEC Privilege
Supported Modes All Modes
Default None
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
debug ip dhcp client events
Enable the display of log messages for the following events on DHCP client interfaces:
• IP address acquisition
• IP address release
• Renewal of IP address and lease time
526
Dynamic Host Configuration Protocol