CLI Guide

To disable the debug logs for DHCPv6 relay agent transactions, use the debug
ipv6 dhcp command.
Defaults none
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
default-router
Assign a default gateway to clients based on the address pool.
Syntax
default-router address [address2...address8]
Parameters
address Enter a list of routers that may be the default gateway for
clients on the subnet. You may specify up to eight routers.
List them in order of preference.
Defaults none
Command Modes DHCP <POOL>
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
disable
Disable the DHCP server.
Syntax
disable
DHCP Server is disabled by default. To enable the system to be a DHCP server, use
the no disable command.
Defaults Disabled
Command Modes DHCP
Supported Modes Full–Switch
Dynamic Host Configuration Protocol
519