CLI Guide

ISCSI TLV Tx Status is disabled
Local FCOE PriorityMap is 0x8
Local ISCSI PriorityMap is 0x10
Remote FCOE PriorityMap is 0x8
Remote ISCSI PriorityMap is 0x8
0 Input TLV pkts, 1 Output TLV pkts, 0 Error pkts,
0 Pause Tx pkts, 0 Pause Rx pkts
show interface pfc statistics
Displays counters for the PFC frames received and transmitted (by dot1p priority class) on an interface.
Syntax
show interface port-type slot/port pfc statistics
Parameters
port-type Enter the port type.
slot/port Enter the slot/port number.
NOTE: This command also enables you to view information corresponding to
a range of ports.
• You can specify multiple ports as slot/port-range. For example, if you
want to display information corresponding to all ports between 1 and 4,
specify the port range as show interfaces interface-type 1/1 -
4
.
Command Modes INTERFACE
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM and added support to display the
interface configurations corresponding to a range of ports.
9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
(Summary)
Dell#show interfaces te 0/3 pfc statistics
Interface TenGigabitEthernet 0/3
Priority Rx XOFF Frames Rx Total Frames Tx Total Frames
--------------------------------------------------------
0 0 0 0
1 0 0 0
2 0 0 0
3 0 0 0
4 0 0 0
5 0 0 0
506
Data Center Bridging (DCB)