CLI Guide

PFC Shared Buffer (in KB) : 832
PFC Available Buffer (in KB) : 1080
show interface dcbx detail
Displays the DCBX configuration on an interface.
Syntax
show interface port-type slot/port dcbx detail
Parameters
port-type Enter the port type.
slot/port Enter the slot/port number.
NOTE: This command also enables you to view information corresponding to
a range of ports.
• You can specify multiple ports as slot/port-range. For example, if you
want to display information corresponding to all ports between 1 and 4,
specify the port range as show interfaces interface-type 1/1 -
4
.
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM and added support to display the
interface configurations corresponding to a range of ports.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
To clear DCBX frame counters, use the clear dcbx counters interface
stack-unit/port command.
The following describes the show interface dcbx detail command shown in
the following example.
Field Description
Interface Interface type with chassis slot and port number.
Port-Role Configured the DCBX port role: auto-upstream, auto-
downstream, config-source, or manual.
DCBX Operational
Status
Operational status (enabled or disabled) used to elect a
configuration source and internally propagate a DCB
496
Data Center Bridging (DCB)