CLI Guide

Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information By default:
• All 802.1p priorities are grouped in priority group 0.
• 100% of the port bandwidth is assigned to priority group 0. The complete
bandwidth is equally assigned to each priority class so that each class has 12 to
13%.
NOTE: Please note that Dell Networking does not recommended to use
this command as it has been deprecated in the current 9.4(0.0) release. A
warning message appears when you try to run this command indicating
that you have to use the dcb-map commands in the future.
scheduler
Configure the method used to schedule priority traffic in port queues.
Syntax
scheduler value
To remove the configured priority schedule, use the no scheduler command.
Parameters
value Enter schedule priority value. The valid values are:
• strict: strict-priority traffic is serviced before any other
queued traffic.
• werr: weighted elastic round robin (werr) provides low-
latency scheduling for priority traffic on port queues.
Defaults Weighted elastic round robin (WERR) scheduling is used to queue priority traffic.
Command Modes POLICY-MAP-OUT-ETS
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
494
Data Center Bridging (DCB)