CLI Guide

fcoe priority-bits

Configure the FCoE priority advertised for the FCoE protocol in application priority TLVs.

Syntax

fcoe priority-bits priority-bitmap

To remove the configured FCoE priority, use the no fcoe priority-bits

command.

Parameters

priority-bitmap Enter the priority-bitmap range. The range is from 1 to FF.

Defaults 0x8

Command Modes PROTOCOL LLDP

Supported Modes Programmable-Mux (PMUX)

Full–Switch

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

9.4(0.0) Supported on the FN I/O Aggregator.

9.3(0.0) Introduced on the FC Flex IO module installed in the M I/O

Aggregator.

Usage Information This command is available at the global level only.

iscsi priority-bits

Configure the iSCSI priority advertised for the iSCSI protocol in application priority TLVs.

Syntax

iscsi priority-bits priority-bitmap

To remove the configured iSCSI priority, use the no iscsi priority-bits