CLI Guide

• manual: configures the port to operate only on
administer-configured DCB parameters. The port does
not accept a DCB configuration received form a peer or
a local configuration source.
Defaults Manual
Command Modes INTERFACE PROTOCOL LLDP
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.3(0.0) Introduced on the FC Flex IO module installed in the M I/O
Aggregator.
Usage Information
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Configure DCBX operation at the INTERFACE level on a switch or globally on the
switch. To verify the DCBX configuration on a port, use the show interface
dcbx detail command.
dcbx version
Configure the DCBX version used on the interface.
Syntax
dcbx version {auto | cee | cin | ieee-v2.5}
To remove the DCBX version, use the no dcbx version {auto | cee | cin
| ieee-v2.5} command.
Parameters
auto | cee | cin |
ieee-v2.5
Enter the DCBX version type used on the interface, where:
• auto: configures the port to operate using the DCBX
version received from a peer.
• cee: configures the port to use CEE (Intel 1.01).
• cin: configures the port to use Cisco-Intel-Nuova
(DCBX 1.0).
• ieee-v2.5: configures the port to use IEEE 802.1az
(Draft 2.5).
Defaults Auto
Data Center Bridging (DCB)
477