CLI Guide

dcb-map stack-unit all stack-ports all
Apply the specified DCB map on all ports of the switch stack.
Syntax
dcb-map stack-unit all stack-ports all dcb-map-name
To remove the PFC and ETS settings in a DCB map from all stack units, use the no
dcb-map stack-unit all stack-ports all command.
Parameters
dcb-map-name Enter the name of the DCB map.
Defaults None
Command Modes CONFIGURATION
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.3(0.0) Introduced on the FC Flex IO Modules with I/O Aggregator.
Usage Information The dcb-map stack-unit all stack-ports all command overwrites any
previous DCB maps applied to stack ports.
dcbx-port role
Configure the DCBX port role the interface uses to exchange DCB information.
Syntax
dcbx port-role {config-source | auto-downstream | auto-upstream
| manual}
To remove DCBX port role, use the no dcbx port-role {config-source |
auto-downstream | auto-upstream | manual} command.
Parameters
config-source |
auto-downstream
| auto-upstream |
manual
Enter the DCBX port role, where:
• config-source: configures the port to serve as the
configuration source on the switch.
• auto-upstream: configures the port to receive a peer
configuration. The configuration source is elected from
auto-upstream ports.
• auto-downstream: configures the port to accept the
internally propagated DCB configuration from a
configuration source.
476
Data Center Bridging (DCB)