CLI Guide

on the same port pipe, only a single copy of the policy is written (only one FP entry
is used).
NOTE: An ACL itself may still require more that a single FP entry, regardless of
the number of interfaces. For more information, refer to the IP Access Control
Lists, Prefix Lists, and Route-mapsections in the Dell Networking Operating
System Configuration Guide.
show cam-acl
Display the details of the CAM profiles on the chassis and all stack units.
Syntax
show cam-acl
Defaults none
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The display reflects the settings implemented with the cam-acl command.
Example (Default)
Dell#show cam-acl
-- Chassis Cam ACL --
Current Settings(in block sizes)
1 block = 128 entries
L2Acl : 6
Ipv4Acl : 4
Ipv6Acl : 0
Ipv4Qos : 2
L2Qos : 1
L2PT : 0
IpMacAcl : 0
VmanQos : 0
VmanDualQos : 0
EcfmAcl : 0
FcoeAcl : 0
iscsiOptAcl : 0
ipv4pbr : 0
vrfv4Acl : 0
Openflow : 0
fedgovacl : 0
nlbclusteracl: 0
-- stack-unit 0 --
Current Settings(in block sizes)
1 block = 128 entries
L2Acl : 6
Ipv4Acl : 4
Content Addressable Memory (CAM)
445