CLI Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.7(0.0) Added the keyword nlbcluster ACL.
9.4.(0.0) Added support for PBR.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
Save the new CAM settings to the startup-config (write-mem or copy run
start) then reload the system for the new settings to take effect.
The total amount of space allowed is 16 FP Blocks. System flow requires three
blocks; these blocks cannot be reallocated. The ipv4acl profile range is from 1 to
4.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
On the switch, there can be only one odd number of Blocks in the CLI
configuration; the other Blocks must be in factors of two. For example, a CLI
configuration of 5+4+2+1+1 Blocks is not supported; a configuration of 6+4+2+1
Blocks is supported.
Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which
is from 0 to 10. The ipv6acl allocation must be a factor of two (2, 4, 6, 8, 10).
cam-optimization
Optimize CAM utilization for QoS Entries by minimizing require policy-map CAM space.
Syntax
cam-optimization [qos]
Parameters
qos Optimize CAM usage for QoS.
Defaults Disabled.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information When you enable this command, if a Policy Map containing classification rules (ACL
and/or dscp/ ip-precedence rules) is applied to more than one physical interface
444
Content Addressable Memory (CAM)