CLI Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
This command turns on BGP soft-reconfiguration inbound debugging for IPv6
unicast routes. If no neighbor is specified, debug is turned on for all neighbors.
ipv6 prefix-list
Configure an IPv6 prefix list.
Syntax
ipv6 prefix-list prefix-list name
Parameters
prefix-list name Enter the name of the prefix list.
NOTE: There is a 140-character limit for prefix list
names.
Defaults none
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
show ipv6 prefix-list — View the selected IPv6 prefix-list.
show ipv6 prefix-list
Displays the specified IPv6 prefix list.
Syntax
show ipv6 prefix-list detail {prefix-list name} | summary
Parameters
detail Display a detailed description of the selected IPv6 prefix list.
prefix-list name Enter the name of the prefix list.
438
Border Gateway Protocol IPv4 (BGPv4)