CLI Guide

peer-group name Clear and reapply policies for all BGP routers in the specified
peer group.
ipv6 unicast soft Clear and reapply policies for all IPv6 unicast routes.
in Reapply only inbound policies.
NOTE: If you enter soft, without an in or out option,
both inbound and outbound policies are reset.
out Reapply only outbound policies.
NOTE: If you enter soft, without an in or out option,
both inbound and outbound policies are reset.
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
debug ip bgp ipv6 unicast soft-reconfiguration
Enable soft-reconfiguration debugging for IPv6 unicast routes.
Syntax
debug ip bgp [ipv4-address | ipv6-address | peer-group-name]
ipv6 unicast soft-reconfiguration
To disable debugging, use the no debug ip bgp [ipv4-address | ipv6-
address | peer-group-name] ipv6 unicast soft-reconfiguration
command.
Parameters
ipv4-address |
ipv6-address
Enter the IP address of the neighbor on which you want to
enable soft-reconfiguration debugging.
peer-group-name Enter the name of the peer group on which you want to
enable soft-reconfiguration debugging.
ipv6 unicast Debug soft reconfiguration for IPv6 unicast routes.
Defaults Disabled.
Command Modes EXEC Privilege
Supported Modes Full–Switch
Border Gateway Protocol IPv4 (BGPv4)
437