CLI Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
The following describes the show ip bgp flap command shown in the
following example.
Field Description
Network Displays the network ID to which the route is flapping.
From Displays the IP address of the neighbor advertising the
flapping route.
Flaps Displays the number of times the route flapped.
Duration Displays the hours:minutes:seconds since the route first
flapped.
Reuse Displays the hours:minutes:seconds until the flapped route
is available.
Path Lists all the ASs the flapping route passed through to reach
the destination network.
Example
Dell>show ip bgp flap-statistics
BGP table version is 210851, local router ID is 63.114.8.2
Status codes: s suppressed, d damped, h history, * valid, >
best
Path source: I - internal, a - aggregate, c - confed-external,
r - redistributed, n - network
Origin codes: i - IGP, e - EGP, ? - incomplete
Network From Flaps Duration Reuse
Path
Dell>
show ip bgp inconsistent-as
View routes with inconsistent originating autonomous system (AS) numbers; that is, prefixes that are
announced from the same neighbor AS but with a different AS-Path.
Syntax
show ip bgp [ipv4 unicast] inconsistent-as
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Border Gateway Protocol IPv4 (BGPv4)
411