CLI Guide

role receiver-only Enter the keyword role receiver-only to designate the
local router to support graceful restart as a receiver only.
Defaults as above
Command Modes ROUTER BGP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information This feature advertises to BGP neighbors through a capability advertisement. In
Receiver Only mode, BGP saves the advertised routes of peers that support this
capability when they restart.
neighbor local-as
To accept external routes from neighbors with a local AS number in the AS number path, configure
Internal BGP (IBGP) routers.
Syntax
neighbor {ip-address | peer-group-name} local-as as-number [no-
prepend]
To return to the default value, use the no neighbor {ip-address | peer-
group-name} local-as command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group-name Enter the name of the peer group to set the advertisement
interval for all routers in the peer group.
as-number Enter the AS number to reset all neighbors belonging to that
AS. The range is from 0 to 65535 (2 byte), from 1 to
4294967295 (4 byte) or from 0.1 to 65535.65535 (dotted
format).
no prepend Specifies that local AS values do not prepend to
announcements from the neighbor.
Defaults Not configured.
Command Modes ROUTER BGP
Supported Modes Full–Switch
378
Border Gateway Protocol IPv4 (BGPv4)