CLI Guide

Defaults Not configured.

Command Modes ROUTER BGP

Supported Modes Full–Switch

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.

neighbor distribute-list

Distribute BGP information via an established prefix list.

Syntax

neighbor {ip-address | peer-group-name} distribute-list prefix-

list-name {in | out}

To delete a neighbor distribution list, use the no neighbor {ip-address |

peer-group-name} distribute-list prefix-list-name {in | out}

command.

Parameters

ip-address Enter the IP address of the neighbor in dotted decimal

format.

peer-group-name Enter the name of the peer group to apply the distribute list

filter to all routers in the peer group.

prefix-list-name

Enter the name of an established prefix list.

If the prefix list is not configured, the default is permit (to

allow all routes).

in Enter the keyword in to distribute only inbound traffic.

out Enter the keyword out to distribute only outbound traffic.