CLI Guide

seconds Enter a number as the time interval, in seconds, before BGP
route updates are sent. The range is from 0 to 3600
seconds.
Defaults none
Command Modes ROUTER BGP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
neighbor allowas-in
Set the number of times an AS number can occur in the AS path.
Syntax
neighbor {ip-address | peer-group-name} allowas-in number
To return to the default value, use the no neighbor {ip-address | peer-
group-name} allowas-in command.
Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
peer-group-name Enter the name of the peer group to set the advertisement
interval for all routers in the peer group.
number Enter a number of times to allow this neighbor ID to use the
AS path. The range is from 1 to 10.
Defaults Not configured.
Command Modes ROUTER BGP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
bgp four-octet-as-support — enables 4-byte support for the BGP process.
Border Gateway Protocol IPv4 (BGPv4)
373