CLI Guide

Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
bfd interval
Specify non-default BFD session parameters beginning with the transmission interval.
Syntax
bfd interval interval min_rx min_rx multiplier value role
{active | passive}
Parameters
interval
milliseconds
Enter the keywords interval to specify non-default BFD
session parameters beginning with the transmission interval.
The range is from 50 to 1000. The default is 200.
min_rx
milliseconds
Enter the keywords min_rx to specify the minimum rate at
which the local system would like to receive control packets
from the remote system. The range is from 50 to 1000. The
default is 200.
multiplier value Enter the keywords multiplier to specify the number of
packets that must be missed in order to declare a session
down. The range is from 3 to 50. The default is 3.
role [active |
passive]
Enter the role that the local system assumes:
• Active — The active system initiates the BFD session.
Both systems can be active for the same session.
• Passive — The passive system does not initiate a
session. It only responds to a request for session
initialization from the active system.
The default is Active.
Defaults Refer to Parameters.
Command Modes INTERFACE
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
330
Bidirectional Forwarding Detection (BFD)