CLI Guide

destination Enter the IP address of the network or host to which the
packets are sent.
dscp Enter the keyword dscp to deny a packet based on the
DSCP value. The range is 0 to 63.
message-type (OPTIONAL) Enter an ICMP message type, either with the
type (and code, if necessary) numbers or with the name of
the message type. The range is 0 to 255 for ICMP type and 0
to 255 for ICMP code.
count (OPTIONAL) Enter the keyword count to count packets the
filter processes.
byte (OPTIONAL) Enter the keyword byte to count bytes the
filter processes.
order (OPTIONAL) Enter the keyword order to specify the QoS
priority for the ACL entry. The range is 0 to 254 (where 0 is
the highest priority and 254 is the lowest; lower-order
numbers have a higher priority). If you do not use the
keyword order, the ACLs have the lowest order by default
(
255).
fragments Enter the keyword fragments to use ACLs to control
packet fragments.
threshold-in msgs
count
(OPTIONAL) Enter the threshold-in-msgs keyword
followed by a value to indicate the maximum number of
ACL logs that can be generated, exceeding which the
generation of ACL logs is terminated with the seq, permit,
or
deny commands. The threshold range is from 1 to 100.
Defaults
By default, 10 ACL logs are generated if you do not specify the threshold explicitly.
The default frequency at which ACL logs are generated is five minutes. By default,
flow-based monitoring is not enabled.
Command Modes CONFIGURATION-IP ACCESS-LIST-STANDARD
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Added support for flow-based monitoring on the MXL
10/40GbE Switch IO Module platform.
9.3(0.0) Added the support for logging of ACLs on the MXL
10/40GbE Switch IO Module platform.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
270
Access Control Lists (ACL)