CLI Guide

extended access-lists. This mechanism copies all incoming or outgoing packets on
one port and forwards (mirrors) them to another port. The source port is the
monitored port (MD) and the destination port is the monitoring port (MG).
Related
Commands
deny — configures a filter to drop packets.
permit — configures a filter to forward packets.
seq — assigns a sequence number to a deny or permit filter in an IP access list
while creating the filter.
deny tcp
Configure a filter that drops transmission control protocol (TCP) packets meeting the filter criteria.
Syntax
deny tcp {source mask | any | host ip-address} [bit] [operator
port [port]] {destination mask | any | host ip-address} [dscp]
[bit] [operator port [port]] [count [byte] [order] [fragments]
[threshold-in-msgs [count]]
To remove this filter, you have two choices:
• Use the no seq sequence-number command if you know the filter’s
sequence number.
• Use the no deny tcp {source mask | any | host ip-address}
{destination mask | any | host ip-address} command.
Parameters
source Enter the IP address of the network or host from which the
packets are sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The
mask, when specified in A.B.C.D format, may be either
contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject
to the filter.
host ip-address Enter the keyword host then the IP address to specify a
host IP address.
dscp Enter this keyword dscp to deny a packet based on the
DSCP value. The range is from 0 to 63.
bit Enter a flag or combination of bits:
• ack: acknowledgement field
• fin: finish (no more data from the user)
• psh: push function
• rst: reset the connection
244
Access Control Lists (ACL)