CLI Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell(config-std-nacl)#show conf
!
ip access-list standard test
remark 5 Permit traffic from XYZ Inc.
seq 5 permit 1.1.1.0/24 count
remark 10 Deny traffic from ABC
seq 10 deny 2.1.1.0/24 count
Dell(config-std-nacl)#
Common IP ACL Commands
The following commands are available within both IP ACL modes (Standard and Extended) and do not
have mode-specific options. When an ACL is created without a rule and then is applied to an interface,
ACL behavior reflects an implicit permit.
The switch supports both Ingress and Egress IP ACLs.
NOTE: Also refer to the Commands Common to all ACL Types section.
access-class
Apply a standard ACL to a terminal line.
Syntax
access-class access-list-name [ipv4 | ipv6]
Parameters
access-list-name Enter the name of a configured Standard ACL, up to 140
characters.
ipv4 Enter the keyword ipv4 to configure an IPv4 access class.
ipv6 Enter the keyword ipv6 to configure an IPv6 access class.
Defaults Not configured.
Command Modes LINE
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
168
Access Control Lists (ACL)