CLI Guide

show hardware layer3
Display Layer 3 ACL or QoS data for the selected stack member and stack member port-pipe.
Syntax
show hardware layer3 {acl | qos} stack-unit 0–5 port-set 0–0
Parameters
acl | qos Enter either the keyword acl or the keyword qos to select
between ACL or QoS data.
stack-unit 0–5 Enter the keywords stack-unit then a numeral from 0 to
5 to select a stack ID.
port-set 0–0 Enter the keyword port-set with a port-pipe number.
Defaults none
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
diag stack-unit
Run offline diagnostics on a stack unit.
Syntax
diag stack-unit number {alllevels | level0 | level1 | level2
[verbose no-reboot]| terminate| interactive test <id>}
Parameters
number Enter the stack-unit number. The range is from 0 to 5.
alllevels Enter the keyword alllevels to run the complete set of
offline diagnostic tests.
level0 Enter the keyword level0 to run Level 0 diagnostics. Level
0 diagnostics check for the presence of various
components and perform essential path verifications. In
addition, they verify the identification registers of the
components on the board.
level1 Enter the keyword Level1 to run Level 1 diagnostics. Level
1 diagnostics is a smaller set of diagnostic tests with support
for automatic partitioning. They perform status/self test for
all the components on the board and test their registers for
appropriate values. In addition, they perform extensive tests
on memory devices (for example, SDRAM, flash, NVRAM,
EEPROM, and CPLD) wherever possible. There are no tests
1570
Debugging and Diagnostics