CLI Guide

Command Modes VRRP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
To guarantee that a VRRP group becomes MASTER, configure the VRRP group’s
virtual address with same IP address as the interface’s primary IP address and
change the priority of the VRRP group to 255.
If you set the priority command to 255 and the virtual-address is not equal
to the interface’s primary IP address, an error message appears.
NOTE: Configuring VRRP priority 255 on an interface on which DHCP Client is
enabled is not supported.
show config
View the non-default VRRP configuration.
Syntax
show config [verbose]
Parameters
verbose (OPTIONAL) Enter the keyword verbose to view all VRRP
group configuration information, including defaults.
Command Modes VRRP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell(conf-if-vrid-4)#show con
vrrp-group 4
virtual-address 119.192.182.124
!
1534
Virtual Router Redundancy Protocol (VRRP)