CLI Guide

disable
Disable a VRRP group.
Syntax
disable
To re-enable a disabled VRRP group, use the no disable command.
Defaults Enabled.
Command Modes VRRP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information To enable VRRP traffic, assign an IP address to the VRRP group using the
virtual-address command and enter no disable.
Related
Commands
virtual-address — specifies the IP address of the virtual router.
hold-time
Specify a delay (in seconds) before a switch becomes the MASTER virtual router. By delaying the
initialization of the VRRP MASTER, the new switch can stabilize its routing tables.
Syntax
hold-time {seconds | centisecs centisecs}
To return to the default value, use the no hold-time command.
Parameters
seconds Enter a number of seconds. The range is from 0 to 65535.
The default is zero (0) seconds.
centisecs
centisecs
Enter the keyword centisecs then the number of
centisecs in units of 25 centisecs. The range is from 0 to
65525 in units of 25 centisecs.
Defaults zero (0) seconds
Command Modes VRRP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
1532
Virtual Router Redundancy Protocol (VRRP)