CLI Guide

Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Supported on the M I/O Aggregator.
Usage Information To configure the VLAN from where the VLT peer forwards packets received over
the VLTi from an adjacent VLT peer that is down, use the peer-down-vlan
parameter. To ensure that the DHCP discover packets are forwarded to the VLAN
that has the DHCP server, use this configuration.
peer-routing
Enable L3 VLT peer-routing. This command is applicable for both IPV6/ IPV4.
Syntax
peer-routing
To disable L3 VLT peer-routing, use the no peer-routing command.
Defaults Disabled.
Command Modes VLT DOMAIN (conf-vlt-domain)
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Added the IPV6/IPV4 support on the MXL.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
peer-routing-timeout
Configure the timeout for the software to wait before connecting to a VLT peer with a Down status. This
command is applicable for both IPV6/ IPV4.
Syntax
peer-routing-timeout value
To restore the default value, use the no peer-routing-timeout command.
Parameters
value Enter the timeout value in seconds. The range is from 1 to
65535. The default value is 0 (no timeout).
Command Modes VLT DOMAIN (conf-vlt-domain)
Supported Modes Full–Switch
1514
Virtual Link Trunking (VLT)