CLI Guide

Usage Information To abort VLT delay restore timer as the maximum threshold, the maximum time
interval is applied to hold down ICL peer-up in the start-up configurations during
the reload.
lacp ungroup member-independent
Prevent possible loop during the bootup of a VLT peer switch or a device that accesses the VLT domain.
Syntax
lacp ungroup member-independent {vlt | port-channel}
Parameters
port-channel Force all LACP port-channel members to become
switchports.
vlt Force all VLT LACP members to become switchports.
Defaults Not configured.
Command Modes CONFIGURATION
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Supported on the M I/O Aggregator.
Usage Information
LACP on the VLT ports (on a VLT switch or access device), which are members of
the virtual link trunk, is not brought up until the VLT domain is recognized on the
access device.
To ungroup the VLT and port-channel configurations, use the no lacp ungroup
member independent command on a VLT port channel, depending on whether
the port channel is VLT or non-VLT.
Example
Dell(conf)#lacp ungroup member-independent ?
port-channel LACP port-channel members become
switchports
vlt All VLT LACP members become
switchports
1512
Virtual Link Trunking (VLT)