CLI Guide

• Green: High priority packets that are the least preferred
to be dropped.
• Yellow: Lower priority packets that are treated as best-
effort.
Defaults All the packets on egress are marked with DEI 0.
Command Modes INTERFACE
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information You must first enable DEI for this configuration to take effect.
Related
Commands
dei enable — enables DEI.
member
Assign a stackable VLAN access or trunk port to a VLAN. The VLAN must contain the vlan-stack
compatible command in its configuration.
Syntax
member interface
To remove an interface from a Stackable VLAN, use the no member interface
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
Defaults Not configured.
Command Modes conf-if-vl-<vlan-id>-stack
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
1500
VLAN Stacking